OPENING HOURS SIGN
⚠️ Usage & Installation Precautions
Although suitable for outdoor use, we recommend installing the sign under an eaves or awning to protect it from direct rain and wind.
Dirt, oil, grease, or moisture on the mounting wall, glass, or component surfaces will reduce adhesion and may cause the unit to fall.
Before installation, thoroughly degrease the surfaces with alcohol or wipe clean with water, and allow them to dry completely.
The double-sided tape requires approximately 24 hours to cure completely.
During this period, always secure the components temporarily with masking tape to prevent shifting or falling.
When applying temporary tape, ensure it does not overlap with any printed text or graphics on the plate's surface.
Peeling off tape from printed areas may damage or peel away the print.
■ Package Contents
- Printed Plate (Outdoor Main Plate) × 1
- Frame Part for Glass Mounting (*Used only for glass installation) × 1
- Business Hours Magnet Sheet × 1
- Heavy-Duty Double-Sided Adhesive Tape (referred to as "double-sided tape" below) × 8 strips
Printed Plate
Frame Part for Glass Mounting
■ Assembly Instructions
*The indoor frame part is used only when mounting on a glass surface.
1. Clean the Mounting Surfaces
Thoroughly clean the installation surface (wall or glass) and the adhesive-mating surfaces of each part (plate and frame part).
Degrease with alcohol or wipe clean with water, then allow all surfaces to dry completely.
2. Apply Tape to the Printed Plate
Apply the included double-sided tape strips along the back edges (lip) of the printed plate, pressing them firmly with your fingers to secure the bond.
Once securely bonded, peel off the release paper from the tape.
*If mounting on glass, carefully apply the double-sided tape directly along the edges of the printed plate so that the tape will remain perfectly hidden behind the indoor frame part.
3. Mount the Printed Plate (Outdoor Side)
Align the printed plate with your desired installation spot and press the entire surface firmly for approximately 30 seconds to bond securely.
4. Mount the Glass Mounting Frame (Indoor Side) *Only for glass installation
Align the frame part so that it directly overlaps with the printed plate installed on the outside, sandwiching the glass between them.
Using the double-sided tape, mount the glass mounting frame onto the indoor side of the glass in the same manner, pressing firmly for approximately 30 seconds.
*Sandwiching the glass from both sides hides the adhesive tape from the inside, ensuring a clean, elegant look while reinforcing the hold.
5. Temporary Support & Curing
After mounting, the double-sided tape requires approximately 24 hours to cure completely.
During this time, please use commercially available masking tape to temporarily hold the parts to the glass and prevent shifting or falling.
*Note: Ensure the temporary masking tape does not overlap with any printed areas, as peeling it off may damage or pull away the print.
