CUSTOM SQUARE STOOL
Before Use
• Load capacity (evenly distributed): approx. 80 kg (176 lb).
• Do not stand on the top or use the stool as a step.
• Do not sit on the stool for 24 hours after assembly, until the tape has fully bonded.
⚠️ Precautions for Applying Double-Sided Adhesive Tape
• Apply Firm Pressure: Apply firm, even pressure across the surface after placement (pressure-sensitive adhesive).
• 24-Hour Bonding Period: It takes approximately 24 hours for the tape to achieve its full bonding strength.
• Non-Repositionable: Once applied, the tape cannot be repositioned. Peeling it off will compromise its adhesive performance.
• Low-Temperature Sensitivity: In cold environments, the adhesive tape may not achieve its optimal bonding strength. When installing in low temperatures, gently warm the tape with a hair dryer before application.
Package Contents
• Stool Body
• Top Plate (300 × 300 mm / 10 mm thick) (shipped separately from the body)
• Double-Sided Adhesive Tape × 5 strips
Assembly Instructions
① Place the stool body on a flat floor. Wipe any dust or dirt from the recess on the top (where the plate sits) with a dry cloth.
② Apply the 5 included strips of double-sided tape inside the recess, spacing them evenly at the four corners and in the center.
＊Do not cover the hole (Ø20 mm) in the top.
Peel the liner from one side of the tape and apply it to the top.
Remove the top liner just before placing the plate.
③ Peel off the tape liners. Check the orientation of the plate (the direction of the text), then slowly lower the plate into the recess.
＊The plate cannot be repositioned once placed. Check the orientation carefully before setting it down.
④ Press firmly over the entire plate by hand to bond the tape.
＊It takes approximately 24 hours for the tape to reach full bonding strength.
Check the orientation before placing the plate.
If the stool wobbles
Turn the four adjustable feet on the bottom to level the stool.
