How to apply the Printed Sticker
How to Apply The Printed Sticker
Preparation：Before application, wipe off any dust, dirt, or oil from the surface. Make sure the surface is completely dry.
① Positioning
Before removing the backing paper, place the sheet on the surface to decide the correct position. Mark the area by outlining it with masking tape.
② Marking the Guides
Extend the cross-shaped guide lines printed on the sheet onto the masking tape by drawing matching lines. This will help with accurate alignment.
③ Removing the Backing Paper
Carefully peel off the backing paper from the back of the sheet.
Important:
Make sure the sheet is placed flat on a surface when removing the backing paper. If the application sheet (top transparent layer) bends, cracks may occur in the printed area.
④ Applying the Sheet
Align the sheet with the guide lines and apply it to the surface. Rub firmly from the top using a squeegee or a plastic ruler to ensure proper adhesion.
Tips:
- Lightly heating the surface with a hair dryer can improve adhesion.
(Be careful not to apply too much heat, as some materials such as acrylic may deform.)
- Let the sheet sit for about one day to allow it to fully bond. This will help the printed area adhere cleanly and make removal of the application sheet easier.
- Gently heating while peeling off the application sheet also makes removal easier.
⑤ Finishing
Slowly peel off the application sheet, and the transfer is complete.
